Hampton Direct Router Appendix C User Manual

®
appendix C  
Router Table Handles  
®
 
Determine height for pattern bit.  
Thickness of tail board  
Trim stock or spacer  
At least 1/16" of bearing  
must extend above base  
of router table.  
Pattern bit depth  
1/2" for guide forks  
Base of router  
table  
Routing Pins and Tails  
Grasp the router table handles on the side opposite the board that you wish to  
route, and slide the KATIE JIG™ System toward the bit. Carefully route the  
areas between each of the guide/ tuning forks.  
CAUTION: DO NOT lift the KATIE JIG™ System while the router is running!  
Slide fixture toward bit  
Page C-2  
Copyright © 1997-2000 Hampton House, Inc.  
 

Grace Radio GDI IR3020 User Manual
Haier Washer Dryer HWM90DD User Manual
Harbor Freight Tools Work Light 95388 User Manual
Honeywell Network Card 9782 Series User Manual
Hotpoint Cooktop E302X User Manual
HP Hewlett Packard Car Video System D5063 User Manual
HTC Cell Phone NIKI160 User Manual
Humax DVR OC 5000HD User Manual
Hunter Fan Outdoor Ceiling Fan 42814 01 User Manual
iHome Clock Radio 97 User Manual